Votre Forum

Vous n'êtes pas identifié.

#1 14-01-2020 09:13:39

Peterlovediy
Membre
Date d'inscription: 29-11-2019
Messages: 22

stepper motor review

I have a Lulzbot Taz 4 3D printer with dual extruders. If you knows what a lulzbot Taz 4, 5, or 6 is, then you will also know that the dual extruder is relatively very heavy. I bought 17HS08-1004S to lighten the load. it has improved the print quality a bit especially with the models that have sharp corners and where the X gantry is required to make sudden reverse moves. Other than using shorter screws to mount the motor, it's a direct fit. I did not have to adjust any voltage or calibrate the filament feed rate. The connector for the wire is not included. I've printed two big prints and a couple of medium sized prints with the new setup with no issues. I have not experience any skips or binding with the motors. It was worth the upgrade.

Hors ligne

 

Pied de page des forums

Créez Votre Propre Forum
Insérer vos Graphiques
Dictionnaires de Traduction
Hébergé par ForumCrea.com